|
Halberd battery holders are machined from solid polypropylene and are made to fit Milwaukee M18 batteries.
|
|
|
Virtually indestructible - Because the Halberd battery holder is milled from solid plastic rather than injection molded like other holders, the plastic is very thick and virtually indestructible. Hit it with a hammer, run over it with your truck, mount it in the back or your work van and have all your other equipment fall on top of it - it won't break!
|
|
The latching holder uses the same latches that hold the battery in your tool to hold the battery in the holder. Mount in any orientation and in places where the battery might normally fall out like the back of your truck.
|
|
|
Non-Latching Version - This version does not use the built in latches on your battery. This allows you to quickly and easily grab your battery out of the dock without having to squeeze the latches. This holder must be mounted in an orientation where gravity will keep the battery in the holder.
|
|
Made in the USA by a family owned small business. We care about our environment so we collect and recycle all the plastic that is machined away.
|
|
